Shower liner – Completely waterproof so your shower, you must install a coating on the roadway and sidewalk of the shower. This liner protects the structure in the shower of the infiltration of water, which in turn prevents premature rotting of the border.
Lay the fabric on the shower floor area. Spread the coating and on the walls and on the pavement of the shower, so all three walls and the pavement are covered by the lining. Place the shower liner, at least one foot of each wall is covered. Two times Tuck and lining in the corners there are no additional hardware in the corners. Folding back lining and under the best approach here. Tack coating the wall with a hammer and pointing nails, or a heavy duty stapler. Repeat the fold and fold process at each corner. Flatten and staple lining the walls, adding a staple at every coaching advice.
Smooth the coating on the shower curb. Staple the lining of the border with the stapler once it is snug. Cut the liner at the bottom of the outer part of the edge of water to remove the excess material; do this by running a razor on the surface of the lining. Cut through the liner at the drain with the razor. Run silicone sealant around the bottom of the top half of the leak. Secure the top of the drain to the bottom of the collector, which is installed in the floor of the shower liner. Tighten the drain hardware with a wrench and let the silicone dry.